How To Fool Oxygen Sensors: Tip And More!

Hi! good afternoon, at this moment i will write an article about How To Fool Oxygen Sensors: Tip And More!

Being able to lie to or cheat an oxygen sensor – also called a lambda probe – can only be done by using a dummy oxygen (O2) sensor. If you are interested in knowing this information, read until the end and learn how to fool your car’s oxygen sensors.

Oxygen sensors are part of the motor vehicle emission control system and it may or may not be legal to replace the oxygen (O2) sensor with a dummy or counterfeit sensor (You must review and inform yourself if you can do it in your country).

If you use your vehicle for off-road racing or have engine tuning experience, you may want to bypass the oxygen sensor so you can more effectively tune the engine without worrying about throwing a system error. and check engine light code.

How to trick oxygen sensors?

How to Trick Lambda Sensors
How to Trick Lambda Sensors

The steps and indications that you must follow to bypass or ignore the oxygen sensors are the following:

  1. Raise your vehicle to the jack stands. Raise the vehicle using the front jack point, which is usually located behind the radiator.
  1. Place the jack stands under the front stub welds located under the front doors (under the vehicle) and lower the vehicle onto the jack stands.
  1. Remove the electrical plug from the lambda probes or O2 sensors located under the vehicle. They are usually found in the catalyst. There may be one before and one after the converter.
  1. Remove the lambda sensor from the car by turning it counterclockwise with an oxygen sensor removal tool.
  1. Insert a new dummy oxygen sensor and reconnect the electrical plug to the O2 sensor.
How to Fool O2 Sensors
How to Fool O2 Sensors

Advice:

For specific information on how to remove the oxygen sensor from your vehicle, refer to the manual for your particular vehicle, or go to the link above.

Items you will need

The items you are going to use are:

  • dummy oxygen sensor
  • O2 sensor removal tool
  • 2 jack stands

Being able to lie to or cheat an oxygen sensor – also called a lambda probe – can only be done by using a dummy oxygen (O2) sensor. If you are interested in knowing this information, read until the end and learn how to fool your car’s oxygen sensors.

Oxygen sensors are part of the motor vehicle emission control system and it may or may not be legal to replace the oxygen (O2) sensor with a dummy or counterfeit sensor (You must review and inform yourself if you can do it in your country).

If you use your vehicle for off-road racing or have engine tuning experience, you may want to bypass the oxygen sensor so you can more effectively tune the engine without worrying about throwing a system error. and check engine light code.

How to trick oxygen sensors?

How to Trick Lambda Sensors
How to Trick Lambda Sensors

The steps and indications that you must follow to bypass or ignore the oxygen sensors are the following:

  1. Raise your vehicle to the jack stands. Raise the vehicle using the front jack point, which is usually located behind the radiator.
  1. Place the jack stands under the front stub welds located under the front doors (under the vehicle) and lower the vehicle onto the jack stands.
  1. Remove the electrical plug from the lambda probes or O2 sensors located under the vehicle. They are usually found in the catalyst. There may be one before and one after the converter.
  1. Remove the lambda sensor from the car by turning it counterclockwise with an oxygen sensor removal tool.
  1. Insert a new dummy oxygen sensor and reconnect the electrical plug to the O2 sensor.
How to Fool O2 Sensors
How to Fool O2 Sensors

Advice:

For specific information on how to remove the oxygen sensor from your vehicle, refer to the manual for your particular vehicle, or go to the link above.

Items you will need

The items you are going to use are:

  • dummy oxygen sensor
  • O2 sensor removal tool
  • 2 jack stands

Leave a Comment