How to Check Transmission Fluid in a Toyota Corolla

Hello! good night, at this moment we will write an article about How to Check Transmission Fluid in a Toyota Corolla

Whether you’re going on a long trip or perhaps just as a preventative maintenance precaution, wanting to check your own transmission fluid in a Toyota Corolla is extremely simple and can save you some serious money on repairs if you notice a problem early enough. Read to the end and learn how to check the transmission fluid in a toyota corolla.

Steps to Check the Transmission Fluid in a Toyota Corolla

Checking the transmission fluid when the engine warms up so the petroleum-based fluid expands and gives you a proper reading on the dipstick is the best thing to do.

This little job can be done after a trip to the shop and will take about 60 seconds now that the engine and transmission fluid are warm. Ok, to check the transmission fluid in a Toyota Corolla do the following:

1- Drive a little first.

You should drive the Corolla for about 15 minutes to warm up the engine and expand the transmission fluid. This will give you a more accurate reading on the dipstick, since transmission fluid is created from a petroleum base and will expand when heated.

2- Park the Corolla

Park your car on a flat, level surface and, stepping on the brake, shift the transmission lever through all gears and stay in each gear for about three seconds. Put the Corolla’s shift lever in park and keep the engine running, then release the hood latch.

3- Find the hood release latch

Locate the hood release latch directly under the front center of the hood. Slide it to the left and open the hood; Use the metal hood bracket to secure the hood. It will be resting on the right side of the fender well.

4- Locate the transmission rod.

The dipstick will most likely be red or black on the handle to avoid confusion with the yellow engine oil dipstick. It could be located on the right side of the engine, near the firewall, or it could be to the left of the exhaust manifold at the front of the engine.

5- Take out the dipstick and clean it with a cloth.

Put the dipstick back into the dipstick tube and pull it out again. Compare the reading on the dipstick to the level indicator at the bottom of the dipstick. There should be transmission hot level or safe crossing marks on the dipstick so you can read and see if you need to pour fluid.

6- Add transmission fluid

To add fluid, place the long, narrow neck funnel into the dipstick tube and pour a small amount of approved transmission fluid into the funnel. Knowing the correct amount to pour will be tricky at first, so just do a quick pour and then push the stick back into the stick tube and check again before adding more.

You’ll need to give the fluid time to drip through the dipstick tube to get a more accurate reading. Use only the specified transmission fluid for the vehicle listed in the owner’s manual under the fluid specifications table. Add more liquid if necessary.

7- Check the oil level again

Put the dipstick back in the dipstick tube and check the level again. You may have to repeat this procedure over and over again, but don’t add too much in one fell swoop. There is no way to remove the transmission fluid from the system if you overfill it without dropping the transmission pan.

You should know that this is a completely different and much more complicated procedure. You will most likely have to have it done at a transmission-approved, knowledgeable service center.

Tips

Do not forget the following tips:

• Have the transmission system cleaned according to the recommendations in the maintenance schedule.

• A transmission flush will clean and change all of the transmission fluid, including through the torque converter and not just the four quarts or so in the transmission pan.

• Check the fluid regularly if you had to add something to the Corolla. If you have to keep adding fluid, this may be an indication that you have a more serious problem and your vehicle should be checked by a qualified transmission repair shop or dealer.

Don’t stop reading: How to Replace the Drive Belt on a Corolla

things you will need

The things you will need are the following:

• Long narrow funnel with neck (if needed)

• Automatic transmission fluid that’s right for your Corolla (if needed)

warnings

Be careful of the following:

• Don’t fill with too much liquid.

Whether you’re going on a long trip or perhaps just as a preventative maintenance precaution, wanting to check your own transmission fluid in a Toyota Corolla is extremely simple and can save you some serious money on repairs if you notice a problem early enough. Read to the end and learn how to check the transmission fluid in a toyota corolla.

Steps to Check the Transmission Fluid in a Toyota Corolla

Checking the transmission fluid when the engine warms up so the petroleum-based fluid expands and gives you a proper reading on the dipstick is the best thing to do.

This little job can be done after a trip to the shop and will take about 60 seconds now that the engine and transmission fluid are warm. Ok, to check the transmission fluid in a Toyota Corolla do the following:

1- Drive a little first.

You should drive the Corolla for about 15 minutes to warm up the engine and expand the transmission fluid. This will give you a more accurate reading on the dipstick, since transmission fluid is created from a petroleum base and will expand when heated.

2- Park the Corolla

Park your car on a flat, level surface and, stepping on the brake, shift the transmission lever through all gears and stay in each gear for about three seconds. Put the Corolla’s shift lever in park and keep the engine running, then release the hood latch.

3- Find the hood release latch

Locate the hood release latch directly under the front center of the hood. Slide it to the left and open the hood; Use the metal hood bracket to secure the hood. It will be resting on the right side of the fender well.

4- Locate the transmission rod.

The dipstick will most likely be red or black on the handle to avoid confusion with the yellow engine oil dipstick. It could be located on the right side of the engine, near the firewall, or it could be to the left of the exhaust manifold at the front of the engine.

5- Take out the dipstick and clean it with a cloth.

Put the dipstick back into the dipstick tube and pull it out again. Compare the reading on the dipstick to the level indicator at the bottom of the dipstick. There should be transmission hot level or safe crossing marks on the dipstick so you can read and see if you need to pour fluid.

6- Add transmission fluid

To add fluid, place the long, narrow neck funnel into the dipstick tube and pour a small amount of approved transmission fluid into the funnel. Knowing the correct amount to pour will be tricky at first, so just do a quick pour and then push the stick back into the stick tube and check again before adding more.

You’ll need to give the fluid time to drip through the dipstick tube to get a more accurate reading. Use only the specified transmission fluid for the vehicle listed in the owner’s manual under the fluid specifications table. Add more liquid if necessary.

7- Check the oil level again

Put the dipstick back in the dipstick tube and check the level again. You may have to repeat this procedure over and over again, but don’t add too much in one fell swoop. There is no way to remove the transmission fluid from the system if you overfill it without dropping the transmission pan.

You should know that this is a completely different and much more complicated procedure. You will most likely have to have it done at a transmission-approved, knowledgeable service center.

Tips

Do not forget the following tips:

• Have the transmission system cleaned according to the recommendations in the maintenance schedule.

• A transmission flush will clean and change all of the transmission fluid, including through the torque converter and not just the four quarts or so in the transmission pan.

• Check the fluid regularly if you had to add something to the Corolla. If you have to keep adding fluid, this may be an indication that you have a more serious problem and your vehicle should be checked by a qualified transmission repair shop or dealer.

Don’t stop reading: How to Replace the Drive Belt on a Corolla

things you will need

The things you will need are the following:

• Long narrow funnel with neck (if needed)

• Automatic transmission fluid that’s right for your Corolla (if needed)

warnings

Be careful of the following:

• Don’t fill with too much liquid.