How To Change The Solenoid In A Ford F-150: Discover The Steps!

Hi-ya! good night, now i will write an article about How To Change The Solenoid In A Ford F-150: Discover The Steps!

The Ford F150 relies on a starter solenoid to close the starter circuit for the starter to engage. When the solenoid is damaged or fails it must be replaced. Read on and learn: how to change the solenoid on a ford f-150.

When the solenoid fails, you can manually jump the connection with a screwdriver if you’re a trained mechanic, or you can replace the solenoid and start the truck the normal way. While the labor cost to replace the solenoid shouldn’t be much, you can save that money and simply replace the solenoid yourself if you have mechanical aptitude, a few tools, and about 20 minutes of spare time.

Steps to change the solenoid on a Ford F-150:

  1. Open the lid of your Ford F150 and disconnect the negative battery cable. Push the end of the cable down along the side of the battery so it doesn’t accidentally come into contact with the battery terminal during the replacement procedure.
  1. Place the new solenoid next to the old solenoid on the fender. Disconnect the wiring from the right side of the old solenoid, one wire at a time, using the plug set, and transfer the wiring to the same pole on the new solenoid. Repeat this on the left side until you have transferred all three wires to the new solenoid.
  1. Remove the mounting bolts from the old solenoid with the socket set.. Move the old solenoid to the side, then move the new solenoid into its place. Screw in the two screws by hand and tighten them with the socket wrench set.
  1. Reconnect the negative battery cable to the negative battery terminal with the wrench. Close the cover when you’re done.

Advice

Do not overtighten the solenoid mounting bolts or the solenoid housing could crack from the stress. Once the heads of the bolts touch the body of the solenoid, you have tightened it enough and you should not tighten it any further.

The Ford F150 relies on a starter solenoid to close the starter circuit for the starter to engage. When the solenoid is damaged or fails it must be replaced. Read on and learn: how to change the solenoid on a ford f-150.

When the solenoid fails, you can manually jump the connection with a screwdriver if you’re a trained mechanic, or you can replace the solenoid and start the truck the normal way. While the labor cost to replace the solenoid shouldn’t be much, you can save that money and simply replace the solenoid yourself if you have mechanical aptitude, a few tools, and about 20 minutes of spare time.

Steps to change the solenoid on a Ford F-150:

  1. Open the lid of your Ford F150 and disconnect the negative battery cable. Push the end of the cable down along the side of the battery so it doesn’t accidentally come into contact with the battery terminal during the replacement procedure.
  1. Place the new solenoid next to the old solenoid on the fender. Disconnect the wiring from the right side of the old solenoid, one wire at a time, using the plug set, and transfer the wiring to the same pole on the new solenoid. Repeat this on the left side until you have transferred all three wires to the new solenoid.
  1. Remove the mounting bolts from the old solenoid with the socket set.. Move the old solenoid to the side, then move the new solenoid into its place. Screw in the two screws by hand and tighten them with the socket wrench set.
  1. Reconnect the negative battery cable to the negative battery terminal with the wrench. Close the cover when you’re done.

Advice

Do not overtighten the solenoid mounting bolts or the solenoid housing could crack from the stress. Once the heads of the bolts touch the body of the solenoid, you have tightened it enough and you should not tighten it any further.

Leave a Comment