How To Change The Belt Tensioner On A Toyota RAV4

Hi! good night, now i will created an article about How To Change The Belt Tensioner On A Toyota RAV4

The tensioner belt on a Toyota RAV4 is located in the center of the engine and is used to keep the serpentine belt tight. A bad tensioner pulley will not allow the belt to be tight around the pulleys. Read on and learn how to change the belt tensioner on a Toyota RAV4.

How to Change the Belt Tensioner on a Toyota RAV4

How to Remove the Belt Tensioner on a RAV4
Toyota RAV4 (XA50)

The steps that you must carry out to replace the belt tensioner of a Toyota RAV4 vehicle are the following:

  1. Park your RAV4 on a flat, level surface.. Take the keys out of the ignition to prevent accidental ignition. Open the lid to access the engine compartment and locate the tensioner pulley in the center of the front of the engine.
  1. Place a socket wrench on the bolt to the right of the idler pulley and push down to relieve tension on the belt, then slide the belt off the pulley.
  1. Unscrew the two bolts that hold the tensioner in place with a socket wrench.. There will be one bolt at the top and one on the left.
  1. Remove the tensioner from the motor and replace it with the new one.. Secure the tensioner to the pulley with a socket wrench.
  1. Lower the tensioner with a socket wrench to slide the belt over the pulley. Pull the bolt back to tighten the belt.
  1. Start your SUV and allow it to idle long enough to inspect the belt. Make sure the belt doesn’t come loose as it moves along the pulley.
  1. Close the hood and turn off the engine.

Advice

Now that you know the steps you must follow to change the belt tensioner on a Toyota RAV4, you should know:

  • You can purchase an idler pulley at any Toyota dealer.

Items you will need

You will only use:

  • Glass Key
  • socket wrench set

The tensioner belt on a Toyota RAV4 is located in the center of the engine and is used to keep the serpentine belt tight. A bad tensioner pulley will not allow the belt to be tight around the pulleys. Read on and learn how to change the belt tensioner on a Toyota RAV4.

How to Change the Belt Tensioner on a Toyota RAV4

How to Remove the Belt Tensioner on a RAV4
Toyota RAV4 (XA50)

The steps that you must carry out to replace the belt tensioner of a Toyota RAV4 vehicle are the following:

  1. Park your RAV4 on a flat, level surface.. Take the keys out of the ignition to prevent accidental ignition. Open the lid to access the engine compartment and locate the tensioner pulley in the center of the front of the engine.
  1. Place a socket wrench on the bolt to the right of the idler pulley and push down to relieve tension on the belt, then slide the belt off the pulley.
  1. Unscrew the two bolts that hold the tensioner in place with a socket wrench.. There will be one bolt at the top and one on the left.
  1. Remove the tensioner from the motor and replace it with the new one.. Secure the tensioner to the pulley with a socket wrench.
  1. Lower the tensioner with a socket wrench to slide the belt over the pulley. Pull the bolt back to tighten the belt.
  1. Start your SUV and allow it to idle long enough to inspect the belt. Make sure the belt doesn’t come loose as it moves along the pulley.
  1. Close the hood and turn off the engine.

Advice

Now that you know the steps you must follow to change the belt tensioner on a Toyota RAV4, you should know:

  • You can purchase an idler pulley at any Toyota dealer.

Items you will need

You will only use:

  • Glass Key
  • socket wrench set

Leave a Comment