How To Change The Armrest Cover Of A BMW E46: + Tip!

Hi! good afternoon, today i will made an article about How To Change The Armrest Cover Of A BMW E46: + Tip!

Although BMWs are universally considered high-end vehicles, even if they are durable cars, like any other car, they still deteriorate with the passage of time. If you notice that the armrest cover is deteriorated, then continue reading and learn how to change the armrest cover on a BMW E46.

How to Change the Armrest Cover on a BMW E46

Change The Armrest Cover On A BMW E46
BMW 328Ci E46

E46 is BMW’s internal nomination for the fourth generation of the 3 Series, the E46 3 Series has proven to be one of the most famous iterations of the 3 Series, with outstanding performance across the range.

One area that sees a lot of use is the armrest cover, as at some point it may need to be replaced to keep it looking its best.

  1. Remove the triangular shaped piece of plastic that is located on the inside of the rear view mirror.. You must pull the upper part out with your fingers, then when the pin is released, proceed to pull the piece up and out.
  1. Remove the door panel by undoing or removing the star-shaped screws that hold it. There are three on the door handle, which can be easily unscrewed. The other two are hidden, one of which is located behind a small circular cover installed behind the door handle. Then push the edge of the hood to the left and pull it out. The other is behind the piece that says “AIRBAG“, you need to pry this piece up with a small flathead screwdriver.
  1. Remove the door panel, starting at the corner where the triangular piece of plastic was removed.. Remove the top edge, then the bottom edge, then pull the panel up over the door lock knob and disconnect the speaker harnesses and the wire going to the door panel. Next you must disconnect the controller of the rear view mirror that is on the driver’s side.
  1. Remove the 6 Torx screws that hold the armrest to the door panel, noting the screws that have white paint on them. If you have a torque wrench determine how much force is needed to remove them and tighten them to the same setting during reinstallation later, now if you don’t have a torque wrench line up the paint marks during reinstallation.
  1. Remove the leatherette pad from the top area of ​​the door handle by prying up from the front segment of the door handle.. It must be pulled up from the front due to the small tab located at the back. Go to the back of the armrest and remove the 6 pins holding it in as you go, slide it forward to release the tab when all the pins are out, to remove armrest.
  1. Put the new artificial leather pad on the armrest transferring the peg clips that were on the old trim to the new faux leather pad. She screws the armrest back into the door panel with the Torx screws.
  1. Again reconnect all speaker wires, door handle controller and door handle wire, plus you need to snap the door panel back on the door. Rethread the 5 Torx screws and also reattach the trim that says “AIRBAG” and the round plastic cover that hides the screws.

Advice

Changing the armrest cover of a BMW E46 is not a complicated task, but you do have to be careful to do the procedure well.

Although BMWs are universally considered high-end vehicles, even if they are durable cars, like any other car, they still deteriorate with the passage of time. If you notice that the armrest cover is deteriorated, then continue reading and learn how to change the armrest cover on a BMW E46.

How to Change the Armrest Cover on a BMW E46

Change The Armrest Cover On A BMW E46
BMW 328Ci E46

E46 is BMW’s internal nomination for the fourth generation of the 3 Series, the E46 3 Series has proven to be one of the most famous iterations of the 3 Series, with outstanding performance across the range.

One area that sees a lot of use is the armrest cover, as at some point it may need to be replaced to keep it looking its best.

  1. Remove the triangular shaped piece of plastic that is located on the inside of the rear view mirror.. You must pull the upper part out with your fingers, then when the pin is released, proceed to pull the piece up and out.
  1. Remove the door panel by undoing or removing the star-shaped screws that hold it. There are three on the door handle, which can be easily unscrewed. The other two are hidden, one of which is located behind a small circular cover installed behind the door handle. Then push the edge of the hood to the left and pull it out. The other is behind the piece that says “AIRBAG“, you need to pry this piece up with a small flathead screwdriver.
  1. Remove the door panel, starting at the corner where the triangular piece of plastic was removed.. Remove the top edge, then the bottom edge, then pull the panel up over the door lock knob and disconnect the speaker harnesses and the wire going to the door panel. Next you must disconnect the controller of the rear view mirror that is on the driver’s side.
  1. Remove the 6 Torx screws that hold the armrest to the door panel, noting the screws that have white paint on them. If you have a torque wrench determine how much force is needed to remove them and tighten them to the same setting during reinstallation later, now if you don’t have a torque wrench line up the paint marks during reinstallation.
  1. Remove the leatherette pad from the top area of ​​the door handle by prying up from the front segment of the door handle.. It must be pulled up from the front due to the small tab located at the back. Go to the back of the armrest and remove the 6 pins holding it in as you go, slide it forward to release the tab when all the pins are out, to remove armrest.
  1. Put the new artificial leather pad on the armrest transferring the peg clips that were on the old trim to the new faux leather pad. She screws the armrest back into the door panel with the Torx screws.
  1. Again reconnect all speaker wires, door handle controller and door handle wire, plus you need to snap the door panel back on the door. Rethread the 5 Torx screws and also reattach the trim that says “AIRBAG” and the round plastic cover that hides the screws.

Advice

Changing the armrest cover of a BMW E46 is not a complicated task, but you do have to be careful to do the procedure well.

Leave a Comment